Round Slings - 1 Tonne
Round Slings - 1 Tonne
PLEASE NOTE: All Slings are supplied with the "Original" Certification, We stress that you do not discard it as we do not keep a copy.
Protect the sling from sharp edges by using protective sleeves or corner pieces. Do not pass a sling over sharp corners or edges without adequate protection from abrasion or cutting. Corners with a radius of less than three times the compressed thickness of the sling material are deemed to be sharp. Polyurethane protective covers are recommended when lifting loads of concrete, glass and steel plate. Polyurethane or webbing protective sleeves are recommended when lifting loads of aluminium, panels, machinery, steel pipe or timber.
* Unique Identification Number.
* Certified to AS4497.
* 100% Polyester Inner & Cover
* WLL is clearly marked on each sling.
* International Colour Coded with 1 Strip.
* Safety Factor 7:1
* Flat Thickness 4mm
The Following Must Be Adhered To
* Do not expose to temperatures above 90 degrees C
* Do not load in excess of the rated capacity
* Do not drag on the floor or over abrasive surfaces
* Do not twist, shorten, lengthen, or tie in knots
* Do not pull from under loads that are resting on the sling
* Do not repair any damaged sling
* Do not store in chemically active areas, under ultraviolet light or near heat
* Always protect from sharp edges and corners or abrasive surfaces
* Always inspect before each use
* Always ensure the correct sling is being used for the application
TOLERANCE:
In accordance with AS4497.1, Roundslings shall have an accuracy of +/- 3% of the nominal length expressed in metres.
WARNING: Corners with a radius of less than three times the compressed thickness of the sling material are deemed to be sharp.